ISO 20766-24-2022 pdf free download – Road vehicles — Liquefied petroleum gas (LPG) fuel system components — Part 24: Gas tubes.
This document specifies general requirements and definitions for the gas tube component of liquefiedpetroleum gas fuel, intended for use on the types of motor vehicles as defined in ISO 3833. It alsoprovides general design principles and specifies requirements for instructions and marking.
This document is applicable to vehicles(mono-fuel, bi-fuel or dual-fuel applications)using gaseous fuelsin accordance with ISo 9162.It is not applicable to the following:
a) fuel containers;
b) stationary gas engines;
)container mounting hardware;d)electronic fuel management;e)refuelling receptacles.
lt is recognized that miscellaneous components not specifically addressed herein can be examinedfor compliance with the criteria of any applicable part of the ISO 20766 series, including testing to theappropriate functional tests.
All references to pressure in this document are considered gauge pressures unless otherwise specified.This document applies to devices which have a service pressure in the range of 110 kPa (butane rich at20°C) and 840 kPa (propane at 20 °C), hereinafter referred to in this document.Other service pressurescan be accommodated by adjusting the pressure by the appropriate factor (ratio).
2Normative references
The following documents are referred to in the text in such a way that some or all of their contentconstitutes requirements of this document. For dated references,only the edition cited applies.Forundated references, the latest edition of the referenced document (including any amendments) applies.ISO 20766-1, Road vehicles — Liquefied petroleum gas (LPG) fuel systems components — Part 1:Generalrequirements and definitions
ISo 20766-2，Road vehicles – Liquefied petroleum gas (LPG) fuel systems components — Part 2:Performance and general test methods
3Terms and definitions
For the purposes of this document, the terms and definitions given in IS0 20766-1 and the followingapply.
Specific care shall be taken against galvanic corrosion.
Gas tubes and couplings should mate to avoid galvanic corrosion.
Only straight longitudinal welding (in the direction of the tube itself) is permitted in gas tubes of nonseamless type.
6 Tests
6.1 Applicability
The tests required to be carried out are indicated in Table 1
6.2 Hydrostatic strength
Test the gas tubes according to the procedure for testing hydrostatic strength specified in IlSO 20766-2.The test pressure shall be 2,25 times the working pressure.
6.3High temperature
The gas tubes shall not leak more than 15 cm3/hour (normal) at a room temperature of 20 °C ± 5 °Cwhen subjected to leakage test specified in lso 20766-2 at the maximum operating temperature(65 °C or 85 °C or 120 °C as applicable) and with the pressure equal to 150 % of working pressure. Thecomponent shall be conditioned for at least 8 h at this temperature.
6.4 Low temperature
The gas tubes shall not leak more than 15 cm3/hour (normal) at a room temperature of 20 °C± 5 °Cwhen subjected to leakage test specified in IS0 20766-2 at the minimum operating temperature (-40 °C
or -20 °Cas applicable) and with the pressure equal to 150 % of working pressure.The component shallbe conditioned for at least 8 h at this temperature.
6.5Continued operation
Testthe gas tubes in accordance with the procedure fortesting continued operation given inISO 20766-2for a total of 100 0o0 cycles.
6.6Bending
Test the gas tubes according to the following procedure and acceptance criterion.a) Select a mandrel with an external diameter according to Table 2.ISO 20766-24 pdf download.