IEC 63002-2021 pdf free download – Interoperability specifications and communication method for external power supplies used with computing and consumer electronics devices
Annex B provides further detail on the robustness and interoperability characteristics of uSBType-C and USB Power Delivery solutions.
4.4USB Type-ccurrent
The USB Type-C Current power mode is based on a regulated 5 V power source with up to 3A
operation. This power mode uses a simple analogue method over the uSB Type-CConfiguration Channel (CC) interface fora Source to advertise its available current to a Sink.A usB Type-C Source may advertise default USB Type-C Current (500 mA or 900 mA, based on the version of the USB port and cable), USB Type-C Current at 1,5 A or USB Type-C Current
at 3A.An EPS shall indicate USB BC 1.2 compatibility on the port such that a device(Sink)that doesn’t recognize USB Type-C Current modes but is compatible with USB BC 1.2 can still draw 1,5 A.
4.5usB Power Delivery (uSB PD)
Power transfer at other than 5V or over 3 A shall comply with IEC 62680-1-2(USB PowerDelivery). USB Power Deliverystandardizes the discovery,configuration and functionaloperation of more capable USB Type-C power sources and battery chargers. The USB PDprotocol，operating as a digital communication over the USB Type-C CC interface,enables apredictable,reliable user experience based on a common set of robust mechanisms andcommunication exchanges between the USB Source and the Sink. The comprehensive set ofpower delivery methods supported by the USB PD protocol enables a broad range of batterycharging approaches and profiles that are specific to the design and operation of the devicebeing charged (the Sink) – this enables device designs to evolve and innovate while thecapabilities of a usB PD-based charger can remain a constant.
USB PD protocol is used to provide system control, error detection and handshaking.The fourrequired steps for enabling power delivery are:
1) Source offers its capabilities.
2) Sink requests from the offered capabilities.3) Source accepts the request.
4) Source indicates that it is ready to provide power.
USB PDprotocol can also be used for reporting the status (overcurrent protection,overtemperature protection, overvoltage protection, etc.) of the Source.
The USB PD protocol specifies two principal modes of power transfer that can be implementedby a USB PD Source.
Fixed Supply operation: Provides a set of selectable fixed voltage and current combinations.IEC 62680-1-2 defines voltages that include 5 V,9V,15V and 20 V.The Source can offeras much as 5 A, depending on the cable current rating and selected voltage.
Programmable Power Supply (PPS) operation: Provides granular control of voltage or amaximum regulated source current limit. In PPs mode，the integrity of the connection iscontinually monitored and absence of a handshake message between Source or Sink forces
the connection to lower safe power level.PPS places the burden of regulation in the Sourceinstead of in the Sink, allowing the Sink to better manage thermal rise during higher power
battery charging，which aids in lowering touch temperatures. Standard-defined voltageranges for PPs PDOs are nominally aligned with the defined Fixed Supply PDOs (5 v, 9 v,
15 V and 20 V) with a range minimum of 3,3 V and maximum of 5,9v,11v,16 V and 21 v,respectively.The Source could offer as much as 5 A, depending on the cable current ratingand selected voltage.IEC 63002 pdf download.