IEC 62610-6-2020 pdf free download – Mechanical structures for electrical and electronic equipment – Thermal management for cabinets in accordance with IEC 60297 and IEC 60917 series – Part 6: Air recirculation and bypass of indoor cabinets.
This part of IEC 62610 which deals with thermal management for cabinets in accordance with IEC 60297 and IEC 60917 series, provides compatible measurement methods of recirculation ratio and bypass ratio which are indicators for defining quality of airflow in the forced air cooling that can be commonly applied to indoor cabinets for mounting subrack and/or chassis-based equipment. NOTE 1 Both recirculation and bypass represent leakage airflows, i.e. detrimental phenomena in terms of cooling efficiency; their measurement is obviously aimed at their mitigation.
This document contains the following:
a) the definition of recirculation and bypass flow rates in the cooling of the cabinet,
b) the levels of the recirculation ratio RC,
c) the definition of the formula for the recirculation ratio RC s of forced air cooling subrack and/or chassis-based equipment installed in the cabinet,
d) the definition formula of recirculation ratio RC r and bypass rate BP r of the entire cabinet,
e) the requirements of the measuring method of each temperature necessary for calculating the recirculation ratio RC s , RC r and bypass ratio BP r .
NOTE 2 This document includes the definition of measuring bypass ratio, but excludes the definition of levels of bypass ratio.
The drawings used are not intended to indicate product design. They are only for explanatory indications for defining forced air cooling airflows.
The recirculation and bypass measurement methods dealt with in this document are assumed to be applied to a cabinet installed indoors. The cooling air inlet is at the front or the bottom of the cabinet and the heated air is exhausted to the rear or the top. These methods are also applicable to a cabinet that is installed outdoors and has a cooling device such as a heat exchanger or an air conditioner on the front or the back (see Annex C). The recirculation ratio of a subrack or a cabinet is defined for each individual subrack or chassis- based equipment mounted in the cabinet or for the entire cabinet. The bypass ratio of a cabinet is defined for the entire cabinet.
2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
IEC 60297-3-100, Mechanical structures for electronic equipment – Dimensions of mechanical structures of the 482,6 mm (19 in) series – Part 3-100: Basic dimensions of front panels, subracks, chassis, racks and cabinets
IEC 60917-1, Modular order for the development of mechanical structures for electrical and electronic equipment practices – Part 1: Generic standard
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
IEC Electropedia: available at http://www.electropedia.org/
ISO Online browsing platform: available at http://www.iso.org/obp.IEC 62610-6 pdf download.