IEC-61837-3-2000 pdf free download – Surface mounted piezoelectric devices for frequency control and selection – Standard outlines and terminal lead connections – Part 3: Metal enclosures.
This part of lEC 61837 deals with standard outlines and terminal lead connections as theyapply to SMDs for frequency control and selection in metal enclosures and is based onlEC61240.
2Normative references
The following normative documents contain provisions which,through reference in this text,constitute provisions of this part of IEC 61837. For dated references，subsequentamendments to, or revisions of, any of these publications do not apply.However,parties toagreements based on this part of lEC 61837 are encouraged to investigate the possibillity ofapplying the most recent editions of the normative documents indicated below.For undatedreferences, the latest edition of the normative document referred to applies.Members of lECand lso maintain registers of currently valid International Standards.
IEC 61240:1994,Piezoelectric devices – Preparation of outline drawings of surface mounteddevices (SMD) for frequency control and selection – General rules
3Configuration of enclosures
The enclosures of the surface-mounted devices are made of metal with the formed leadterminals based on the descriptive designation system for semiconductors – devices package.
The configuration symbols are shown as follows:
– DcC(dual chip carrier);
– occ(quad chip carrier);
– ss (special surface-mounted).
4Designation of types
The designation of types is shown on the four parts as follows:
A: Configuration symbol of enclosures:
– DcC (dual chip carrier);
– occ (quad chip carrier);
– ss (special surface-mounted).
B: Structure of terminal leads
– L: folded leads type;
– J: folded leads type;
– leadless type has no mark.
C: Number of terminal leads
D: Serial number of both figures
5 Metal enclosure dimensions
The dimensions given in this standard apply to all the completed SMD for frequency control and selection. Only those dimensions are given which meet the requirements of IEC 61240.
6 Lead connections
Recommendations for the lead connections of all completed SMD for frequency control and selection, except SS-types, are given in the following individual sheets. Lead connections shall always be given in the detail specification.
7 Designation of metal enclosures
The following table sets out the designation of the metal enclosures as outlined in the ensuing specification sheets.IEC-61837-3 pdf download.