AS IEC 62217-2021 pdf free download – Polymeric HV insulators for indoor and outdoor use — General definitions, test methods and acceptance criteria.
6Information on transport, storage and installation
Manufacturers of insulators shall provide appropriate instructions and information coveringgeneral conditions during transport,storage and installation of the insulators. Theseinstructions can include recommendations for cleaning or maintenance.
7 Classification of tests
The tests are divided into four groups as follows:
7.1Design tests
The design tests are intended to verify the suitability of the design， materials and methodof manufacture (technology).
A polymeric insulator design is generally defined by:
– materials of the core, housing and manufacturing method;
– material of the end fittings, their design, and method of attachment;
– layer thickness of the housing over the core (including a sheath where used).Additional parameters defining design may be given in the relevant product standard.
When changes in the design of a polymeric insulator occur，re-qualification shall becarried out according to the prescriptions of the relevant product standard.Typically,onlypart of the tests is repeated.A survey of the tests is given in Annex C.
When a polymeric insulator is submitted to the design tests, it becomes a parent insulatorfor a design class and the results shall be considered valid for the whole class.This testedparent insulator defines a design class of insulators which have the followingcharacteristics:
a) same materials for the core and housing and same manufacturing method;
b) same material of the end fittings，the same design and the same method of attachment;
c) same or greater minimum layer thickness of the housing over the core (including a sheath where used).
Additional parameters defining a class of design may be given in the relevant productstandard.
7.2Type tests
The type tests are intended to verify the main characteristics of a polymeric insulator,which depend mainly on its shape and size. Type tests shall be applied to polymericinsulators belonging to an already qualified design class. The type tests shall be repeatedonly when the type of the polymeric insulator is changed.The parameters defining a typeof polymeric insulator are given in the relevant product standard.
The applicable type tests are given in the relevant product standard.
7.3Sample tests
The sample tests are intended to verify the characteristics of polymeric insulators whichdepend on the quality of manufacture and on the materials used. They are made oninsulators taken at random from lots offered for acceptance.
The applicable sample tests are given in the relevant product standard.7.4Routine tests
These tests are intended to eliminate polymeric insulators with manufacturing defects.They are carried out on every insulator to be supplied.
The applicable routine tests are given in the relevant product standard.
8General requirements for insulator test specimens
Insulator test specimens for tests of polymeric insulators shall be checked prior to tests:
for correct assembly, for example by applying the mechanical routine test specified in therelevant product standard,
by visual examination according to the relevant product standard;.for conformance of dimensions with the actual drawing.
For dimensions d without tolerances the following tolerances are acceptable:.±(0,04 x d + 1,5) mm when d s 300 mm;
±(0,025 x d + 6) mm when d > 300 mm with a maximum tolerance of +50 mm.
The measurement of creepage distances shall be related to the design dimensions andtolerances as determined from the insulator drawing, even if this dimension is greater than thevalue originally specified. When a minimum creepage is specified, the negative tolerance isalso limited by this value.AS IEC 62217 pdf download.