BS ISO 5287-2021 pdf free download – Belt drives — V-belts for the automotive industry — Fatigue test.
This document specifies a fatigue test for the quality control of V-belts (sections AV 10,AV 10X,AV 13,AV13X,AV 17 and AV 17X) intended for driving the auxiliaries of internal combustion engines used forautomotive purposes.
NOTE The dimensional characteristics of these belts and of the corresponding pulleys are the subject of ISo 2790.
Normative references
The following documents are referred to in the text in such a way that some or all of their contentconstitutes requirements of this document. For dated references,only the edition cited applies.Forundated references, the latest edition of the referenced document(including any amendments) applies.ISO 683-1,Heat-treatable steels, alloy steels and free-cutting steels —Part 1:Non-alloy steels for quenchingand tempering
ISo 2790, Belt drives — V-belts for the automotive industry and corresponding pulleys — Dimensions
ISO4287,Geometrical Product Specifications (GPS)— Surface texture: Profile method —Terms, definitionsand surface texture parameters
ISO 6508-1,Metallic materials — Rockwell hardness test — Part 1: Test method
3 Terms and definitions
No terms and definitions are listed in this document.
ISO and lEC maintain terminological databases for use in standardization at the following addresses:- ISO online browsing platform: available at https://www.iso.org/obp
一IEC Electropedia: available at https://www.electropedia.org/
4 Symbols
For the purpose of this document, the following symbols apply.
Symbol Definition Unit
d e1 effective diameter of both the driving and driven pulleys mm
d e2 effective diameter of the idler pulley mm
E centre distance between the driving and driven pulleys mm
F belt tensioning force N
g additional slip
6.1.4 Device, through which tension can be applied to the belt:
a) in the case of the three-pulley test machine layout, an idler pulley (see Figure 1);b) in the case of the two-pulley test machine layout, a movable pulley (see Figure 2).
6.1.5 Means of determining belt slip, to an accuracy of ± 1 %.
The layout of the pulleys and the direction of rotation shall be as shown in Figures 1 and 2.
ln order to accommodate different lengths of belt, the position of the driving and driven elements, andthe position of the idler pulley and its support bracket in the case of the three-pulley test machine, shallbe adjustable so that the test layout of the pulleys is attainable for each belt length.
So that tension can be satisfactorily applied to the belt, and in order to allow for belt stretch, the idlerpulley of the three-pulley test machine and its bearing assembly shall be free to slide, as and whennecessary, in its support bracket along the line of application of the tensioning force. n such a case,the line of action of the tensioning force shall bisect the belt layout angle at the idler pulley, shall passthrough the axis centre of the idler pulley, and shall lie in the plane through the centre of the groove ofthe idler pulley (see Figure 1).
The two-pulley test machine shall be constructed so that one of the units (driven or driving) can bemoved to accommodate belt lengths up to 800 mm (see Figure 2).A method of locking the movable unitin position, with a given tension in the V-belt, shall be provided.
6.2Test pulleys
Test pulleys,which shall comply with the following requirements: be made of steel as defined inISO 683-1, with a surface hardness of 55 HRC, in accordance with ISO 6508-1, and the pulley groovewith a surface roughness such that the arithmetical mean deviation of the evaluated profile,R a, definedby ISO 4287 is lower than 0,8 um.
The characteristics of the test pulleys are given in Figure 3 and Table 1.BS ISO 5287 pdf download.